retrofasad.blogg.se

1. ILO 2 FIRMWARE CD SERIAL
2. ILO 2 FIRMWARE CD UPDATE
3. ILO 2 FIRMWARE CD UPGRADE
4. ILO 2 FIRMWARE CD SOFTWARE

The current firmware version information appears. View ILOM Version Information Using the Web Interface The ILOM firmware version and build number are listed above. Type the version command, which returns output similar to the following: Log in to the ILOM SP and type the default user name ( root) with the default password ( changeme).Īfter you have successfully logged in, the SP displays its default command prompt:Ħ. This will be different for each server.ĥ. Here, 0003BA84D777 is the Ethernet MAC address of the SP. Press Enter on the terminal device to establish a connection between that terminal device and the server’s SP.

ILO 2 FIRMWARE CD SERIAL

If needed, connect a dongle cable to the server module.ģ.Ĝonnect a serial cable from the RJ-45 SER MGT port on the server module dongle or server’s back panel to your terminal device or PC.Ĥ.

ILO 2 FIRMWARE CD SOFTWARE

The ILOM (SP) firmware version and build number are listed above.ġ.Ĝonfigure your terminal device or the terminal emulation software running on a laptop or PC to the following settings:ĨN1: eight data bits, no parity, one stop bitĢ. Where sp_ip_address is the IP address of the server’s service processor.Įnter the default password when you are prompted:Ģ.Ěfter you have successfully logged in, the SP displays its default command prompt:ģ. Using the CLI Through the Management Ethernet Portġ.Ĝonnect an RJ-45 Ethernet cable to the NET MGT Ethernet port.Įstablish an SSH connection using the following command:

ILO 2 FIRMWARE CD UPDATE

When the firmware update is complete, the system automatically reboots. Update the firmware on each service processor (SP) and/or Chassis Monitoring Module (CMM) in the system using the CLI or the web interface.Ħ. Log in as any user with Administrator privileges.ĥ. Copy the image to a TFTP server for a CLI update or to a local file system for a web interface update.Ĥ. When updating to a later firmware release, the preserve configuration option (when enabled) saves your existing configuration in ILOM and restores the configuration after the update process is completed.ģ.This causes ILOM to reboot with the currently installed version of ILOM firmware. A network failure during the firmware file upload results in a time-out.During this time, no other tasks should be performed in ILOM. The firmware update process takes about five minutes to complete.The update process requires less than 20 minutes to complete. Wait until after the update succeeds before making further ILOM configuration changes. To ensure a successful update, do notattempt to modify the ILOM configuration, or use other ILOM Web, CLI, SNMP, or IPMI interfaces, during the flash update process.

ILO 2 FIRMWARE CD UPGRADE

No other tasks can be performed in ILOM until the firmware upgrade is complete and the ILOM is reset. If a graceful shutdown is not possible, ILOM forces a shutdown, which could cause filesystem corruption.Ĭaution - ILOM enters a special mode to load new firmware. ILOM attempts to shut down the OS gracefully.

Review these cautions and these guidelines when updating the firmware.Ĭaution - Shut down your host operating system before proceeding.